GREAT PLAINS PL5700, Руководство оператора

Страница: 30 / 150

Great Plains | 411-681M | 04/08/2021 23
PL5700 Planter Table of Contents Index Operation
2. If installed, remove cylinder locks and stow in
storage position (page 18).
3. If installed, ensure markers are fully folded
(page 27).
4. As equipped, set tractor circuit levers for the
fan(s) and hydraulic drive to “Neutral”.
5. Put the tractor gear in “Neutral”.
6. Use tractor lift circuit to fully raise the planter.
7. Fully lower the two-point hitch.
8. Confirm the wing hooks have been disengaged
from the tongue stop.
9. With your in-cab console, tap the Fold Sequence
softkey from the Home screen.
10. Tap the Fold softkey to set the fold hydraulic
system to active. This is indicated by the Fold
softkey changing to a blue Active Fold softkey.
For partial unfolding, either tap the Stop
softkey (not shown) or set lever to “Neutral”
while the planter is unfolding.
11. Use the tractor fold circuit lever until the planter is
fully unfolded and the tongue hook (1) is latched.
The hydraulic cylinder on the tongue hook
latch will operate automatically during the
fold/unfold procedure.
12. When unfolding is complete, tap the Active Fold
softkey so fold hydraulic system is no longer
active.
With Switch Box
1. Move the planter to level ground with adequate
overhead and side-to-side clearances for the
unfold operation.
2. If installed, remove cylinder locks and stow in
storage position (page 18).
Storage Position
TP-71126a
1
i
TP-71123
1
i
Storage Position
TP-71126a
1