FCA4500
Assembly
29
2019-03-21
560-594Q-ENG
Install Openers
The openers will be shipped assembled and attached
to the their respective attachment bars & will need to
be installed with mounts on to the rear of the frame
sections. See parts manual for the correct opener arm
brackets.
134.Install the opener tubes to the cultivator frame
sections using opener arm brackets. To mount
opener arm bracket use
5
8
x 4
1
32
x 4
1
4
u-bolt ,
5
8
lock washers and
5
8
hex nuts, and either opener
arm mount or these mounts do not have a
hydraulic cylinder.
135.Use opener arm brackets & with
3
4
x 2
1
4
Gr5
hex bolt ,
3
4
lock washers and
3
4
hex nuts, and
opener arm mount
, this mount does have a
hydraulic cylinder and it should already be in place.
136.For outside wing openers use opener arm mount
for the right side and opener arm mount
for the
left side. Use the corresponding opener arm bracket
for mounting to the wings. Refer to the Parts Manual
for parts drawing and list break down.
137.Use
3
4
x 3
1
32
x 4
1
2
u-bolt
,
3
4
lock washer and
3
4
hex nuts, to mount all the opener tubes to opener
mount arms. Use 1 x 7 Gr. 8 special thread hex
bolt
to attach all the mounting arms to the
mounting brackets.
138.The hose holder bars
will need to be installed.
Use
1
2
x 3
1
32
x 4 u-bolt
,
1
2
lock washer and nut
to secure to the attachment bars. The fertilizer hose
retainers
simply snap on to the hose holder bar to
keep the seed tubes in place. You may place these
anywhere along the bar to keep the hoses from
getting tangled.
Refer to the Operator Manual that came with your
seed cart for seed rate information, and for
instructions on how to set up the cart.
Blockage monitor has been connected in numerical
order from left to right, starting on the outside left wing
and moving to the right across the machine.
Completing Setup
139.If the decals are not already in place they can now
be installed.
140.See appropriate pages for decals in the “Parts
Manual” for decal placement.
141.To install new decals:
a.Clean the area on which the decal is to be placed.
b.Peel backing from decal. Press firmly on surface,
being careful not to cause air bubbles under decal.
c.Slowly peel away top protective covering being
careful not to pull decal from implement.
142.If machine has an optional finishing attachment,
refer to the “Parts Manual” for parts break down and
attachment layout drawings of this manual.
143.Be sure to consult the operating instructions,
“Operator’s Manual”, for the first time field
adjustments before going to the field.
4
2
9
10
6
5
1
7
3
11
12
15
13
14
Figure 31
Opener Mounting
43829
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Содержание FCA 4500-7275
