GREAT PLAINS d LS12, Руководство оператора, Страница: 23 / 32

LS10 and LS12 Table of Contents Index Pre-Delivery Instructions
Great Plains | 117-055M | 5/6/19 Table of Contents Index 19
Pre-Delivery Instructions
Install Lights
The lights and harnesses may be installed or may be
shipped in a box to prevent damage to the lighting
system during transport and loading.
If the seeder is delivered with the lights and harnesses not
installed, the dealer must install the lights and harnesses on
the seeder before selling the drill.
Amber Lights Installation
1. On one end of the seeder, remove the handle (1).
Keep the hardware.
2. If necessary, install an amber light (2) on a bracket
(3) with two 1/4 inch self-tapping screws (4).
3. Install the light bracket and handle onto the seeder
with the hardware removed earlier, two hex flange
bolts (5), flat washers (6), and hex flange nuts (7).
4. Repeat the above steps for the other side of the
seeder.
Red Lights Installation
1. Install a red light (1) to a bracket (2) with two 1/4 inch
self-tapping screws (3). Make sure the red light will
be toward the rear of the seeder when installed.
2. Install the bracket to the walkboard with two 3/8 inch
round head bolts (4).
3. Secure one bolt with a flat washer (5), lock washer
(6), and nut (7).
4. Secure the other bolt with a hose clip (8), lock
washer, and nut.
5. Repeat the above steps for the other red light.
Figure 14
Amber Light Installation
71317
1
2
4
7
6
5
3
Figure 15
Red Light Installation
71318
1
2
4
6
7
5
3
8