GREAT PLAINS d LS12, Руководство оператора, Страница: 15 / 32

LS10 and LS12 Table of Contents Index Operating Instructions
Great Plains | 117-055M | 5/6/19 Table of Contents Index 11
Field Operation
Always park implement with plow wings swept back and rear
parking stand in the parking position for maximum stability.
1. Mount seeder on levee plow or other compatible
tillage implement. Position using flat bars (A) under
plow frame and use 3/4-inch bolts to clamp seeder
to plow frame.
2. Connect hydraulic hoses to tractor outlets. See
“
Hydraulic Hose Connections ” on page 9.
3. Fill seeder box with clean seed.
4. Set and calibrate seeding rate as explained under
“
Seeding Rate Adjustment ” on page 13.
5. Adjust seed-distribution door to the desired position.
Refer to “
Distribution Panels ” on page 14.
6. Check that seed-cup-door handles are set the same
across the drill. Refer to “
Seed Cup Doors ” on
page 13.
7. Pull forward, lower implement, engage hydraulic
drive and begin seeding.
Transporting
Transporting implement at high speeds or with a tractor
without enough ballast could lead to loss of vehicle control.
Loss of vehicle control could lead to serious road accidents,
injury and death. Do not exceed 20 mph. Refer to tractor
operator manual for ballast requirements.
Before transporting seeder:
Unload seeder box - The seeder can be transported
with a full box of grain, but the added weight will increase
stopping distance and decrease maneuverability
. Unload
seeder box before transporting if at all possible.
Road rules - Comply with all federal, state and local laws
when traveling on public roads.
Clearance - Remember that the seeder is wider than the
tractor. Allow for safe clearance.
Figure 6
Clamp Seeder to Plow
17993
17993
17992
Figure 7
Hydraulic Connections