4
Hardware for Step 1:
x4
#1 Cam Dowels
STEP 1:
Prepare back leg panels A and B by inserting 4x cam dowels (#1) into the holes as shown.
STEP 2:
Attach 2x side panels (G) to shelf panel E with 4x flat headed
screws (#2).
Repeat for the remaining E and G panels.
These are the lower two shelf components.
Note:
The large drill holes on the side panels to face inwards.
Hardware for Step 2:
x8
#2 Flat Headed Screws
Hardware for Step 3:
STEP 3:
Lay the two shelf components on the floor with the grooved edge facing upward. This is
the back. As shown position back leg panels A and B over the constructed shelves with the
grooves facing up and aligned with the shelves.
Push panels A and B into position. Insert 4 x cam locks (#3) into the large drill holes on the
inside of each G panel, turn clockwise to tighten.
B
#1
#1
#1
#1
A
x4
#3 Cam Locks
TOP
G
G
#2
#2
E
#2
#2
BASE
Using cam locks:
When inserting into the panel, ensure that
each cam lock’s arrow is pointing towards the
drill hole on the side edge of the panel & the
dowel that it will be receiving.
When the panels are in the connected
position, using a screwdriver, turn the cam
lock in a clockwise direction to lock and
secure.
E
E
G
G
G
G
#3
#3
#3
#3
#3
A
B
A
B
