2. Station Assembly
1. Pole Installation
Using a post hole driver (not included), drive the sign post (C) approximately 15-18” into
the ground. Make sure that the “hollow” or “recessed” side of the post is facing where
you want the front of the unit to face. Use a level (not included) to ensure the pole is
standing upright and will properly support the unit. Adjust if necessary.
Need Help? Give us a call!
Great American
•
1-800-231-0329
•
www.gabpproperty.com
3. Station Preparation
18”
1.
Using the first hardware set (D), secure the sign (A) to the top of the steel post (C) with
a bolt and washer at the top of the sign and another at the bottom. The washers should
be next to the printed side (front) of the sign and the nuts are secured on the outside/
back of the post. To ensure the best outcome, make sure the sign is flush with the top of
the pole.
2.
Using the second hardware set (D), attach the dispenser box (B) directly under the
sign leaving about 1” in-between. Open the box, align the holes to the steel post and
attach with the two bolts. The washers should be used on the inside of the box with the
nuts secured to the outside/back of the post.
Open the dispenser box and insert up to 10 header cards of bags (E) onto the prongs in-
side the dispenser. Close the station, pull the top bag through the hole and you’re all set!
Note:
This dispenser fits all types of bags. If you are using boxed bags (Item
PAWBAG3
), you will
need to slip a converter (Great American
Item PAW22
) onto the prongs inside the dispenser and
insert the boxes into the converter.
Please contact us immediately if you have any missing or damaged items
or need any additional assistance. Thank you.
