GRDIAN Charger Plus, Руководство пользователя

Страница: 13 / 18

10
Your vehicle’s electrical system should be completely
OFF. Before connecting, we recommend
setting your voltage setting to the lowest value (11.6V/23.6V).
1.
Connect the
Cigarette Socket
to the
OUTPUT
terminal of the
Charger Plus
.
2. Connect the Component Wires to the INPUT terminal of the Charger Plus .
3.
Once connected, the Charger Plus should turn on. A
RED
indicator should light up.
4. Turn on your vehicle’s electrical system. If installed correctly, the Charger Plus should turn
on and the indicator should turn
GREEN
.
5.
Insert your cigarette charger into the Cigarette Socket. Tape down to make sure it is secure.
NOTE:
If the Charger Plus is not green, make sure you installed your Charger Plus correctly.
Remove the Input Connection, make sure your vehicle’s electrical system is completely OFF.
Re-establish connection by re-inserting the Input Connection and turning your vehicle’s electri-
cal system ON.
CHECKLIST
Make sure you are using a
Constant
and
Switched
Fuse. Refer to
Step 3
.
Make sure the
BATT+
(
YELLOW
) wire is connected to the
Constant
fuse slot. Refer to
Step 6
.
Make sure the ACC+ ( RED) wire is connected to the Switched fuse slot. Refer to Step 6 .
Make sure your
GND
wire is properly connected to a ground point. Refer to
Step 2
and
6
.
Make sure your add-a-fuse is correctly inserted in the right direction. Refer to Step 4 .
Remove the Input Connection. Make sure your vehicle’s electrical system is completely OFF.
Insert the Input Connection back in, and turn on your vehicle to test.
STEP 7: TEST THE CONNECTION
TEST THE CONNECTION