Gravely ZT 50, Руководство владельца/оператора

Страница: 21 / 34

GB - 21
4. Install mower blade on unit (see
REPLACING MOWER BLADE on
page 20).
SERVICING THE BATTERY
NOTE: Unit comes equipped with a
maintenance-free battery that requires no
regular maintenance except cleaning the
terminals.
Battery Removal and Installation
Remove
(Figure 14)
1. Tip seat forward (see TIPPING SEAT
FORWARD on page 17).
2. Disconnect negative (–) cable first, then
positive (+) cable.
3. Remove battery hold-down bracket and
battery from unit.
Install
(Figure 14)
1. Install battery on the unit with battery
hold-down bracket.
2. Connect positive (+) cable first, then
negative (–) cable.
3. Apply petroleum jelly or dielectric grease
to battery cable ends and terminals.
4. Tip seat back (see TIPPING SEAT
FORWARD on page 17).
Cleaning Battery and Battery Cables
(Figure 14)
1. Tip seat forward (see TIPPING SEAT
FORWARD on page 17).
2. Disconnect negative (–) cable first, then
positive (+) cable.
3. Clean battery cable ends, negative (–)
terminal, and positive (+) terminal with a
wire brush and rinse with a weak baking
soda solution.
4. Connect positive (+) cable first, then
negative (–) cable.
5. Apply petroleum jelly or dielectric grease
to battery cable ends and terminals.
6. Tip seat back (see TIPPING SEAT
FORWARD on page 17).
WARNING: Battery posts,
terminals and related accessories
contain lead and lead
compounds, chemicals known to
the State of California to cause
cancer and reproductive harm.
Wash hands after handling.
Figure 13
Sharpen to this Pattern
Discard if
more than
1/2 in.
(1/27 cm)
DO NOT Sharpen to this Pattern
1. Air Lift Erosion
2. Cutting Edge
1
2
Figure 14
1. Positive (+) Terminal
2. Positive (+) Cable
3. Battery Hold-Down Bracket
4. Battery
5. Negative (–) Terminal
6. Negative (–) Cable
3
5
1
2 4
6