Gravely Compact-Pro 34 991088, Руководство оператора

Страница: 20 / 38

EN - 18
CHECK FASTENERS
Check for loose hardware.
LUBRICATE UNIT
See Figure 15.
Apply oil at all pivot points and pin
connections.
Lubricate Caster Fork Bearings
1. Shut off unit, wait for all moving parts to
stop, remove key and engage parking
brake.
2. Remove grease cap.
3. Apply grease to the fitting until new
grease appears at the top of the upper
bearing.
4. Reinstall the grease cap.
Lubricate Caster Wheel Bearings
1. Shut off unit, wait for all moving parts to
stop, remove key and engage parking
brake.
2. Remove wheel from fork.
3. Remove end caps from wheel hub.
4. Apply grease through fitting until grease
squeezes through the seal in the wheel
hub.
5. Wipe off excess grease.
6. Reinstall end caps onto hub.
7. Reinstall wheel into fork. After tightening
bolt, tire should not have any side-to-side
play. Tighten bolt until there is a slight
amount of drag on the wheel bearing. The
wheel should not freewheel when spun.
MAINTENANCE PREPARATION
Before starting any of the following
maintenance procedures:
1. Park unit a flat, level surface.
2. Move steering levers to neutral position.
3. Set parking brake.
4. Stop engine and wait for moving parts to
stop and for hot parts to cool.
5. Disconnect spark plug wires from engine.
NOTICE: Reconnect spark plug wires after
maintenance.
CHECK MOWER BLADES
Check blades for wear. Replace or sharpen
as needed.
Remove Blades
1. Remove hardware securing blades to
spindles and remove blades. Retain all
hardware for reinstallation.
Sharpen Blades
Figure 14
1. Carbon Canister Filter
1
CAUTION: AVOID INJURY. Use
sturdy gloves or padding to
protect hands when working with
mower blades.
Rotation of one blade rotates the
other blades.
CAUTION: DO NOT sharpen
blades while attached to unit.
LUBRICATION LOCATION INTERVAL
Repack Caster Pivot 400 Hrs
Oil All Pivot Points,
Pin Connections
50 Hrs
Figure 15
1. Caster Pivot
1
1