12
INSTALLATION OF POWER BRUSH TO THE
GEAR TWO-WHEEL TRACTOR
1. Install the quick hitch pin into the hitch pin hole on
the brush mounting bracket 1.25" (3.18 cm)
(figure 15).
2. Install double universal joint (item 2) on the tractor
drive shaft. Push the power brush (item 1) all the
way on the quick hitch pin and install the flat washer
and the lynch pin (figure 16).
3. Install control rod (item 13) through control rod
guide (item 11) and install knob (item 9) (figure 14
on page 11).
4. Install control rod (item 13) on latch release with flat
washer (item 14) and cotter pin (item 15)
(figure 16).
WARNING: Unintentional startup or contact with
exposed components can cause severe
personal injury. Stop the engine, wait for all
parts to come to a complete stop, remove the
key from the ignition switch, and disconnect the
spark plug wire before performing any
maintenance, installation, removal, or
adjustment.
Figure 16
Quick Hitch
Pin
Pivot
Washer &
Lynch Pin
Latch
Release
Zerk
