Bedienungsanleitung IFS
Seite 13
2. XZ-P1 (COMPUTER) INTERFACE #23300 or Telemetry Station #23301
To put the receiver into computer programming mode first make sure power is not connected to
the receiver. Now, insert a binding plug into the channel port marked “B” (#23606 XR-12DXT
“Bind”) and then connect power to the receiver (on any servo port). After the STATUS-LED starts
rapidly flashing red, immediately remove the binding plug. The LED will then turn solid red. The
system in now ready for use with the computer interface.
2.1 Reset to defaults
It is possible to reset all of the settings to the factory defaults. When a reset is performed, ALL
settings, including the binding information will be reset. This means that the receiver will have to
be bound again to the Graupner|iFS transmitter module.
To perform a RESET first make sure power is not connected to the receiver. Now, insert a
binding plug into the channel port marked “B” (#23606 XR-12DXT “Bind”) and then connect
power to the receiver (on any servo port). The STATUS-LED will rapidly flash red. After about 7
seconds, the LED will begin to slow flash red and then turn off. Remove the binding plug and
power. The system reset has occurred.
3. USING THE SYSTEM
Caution:
A higher servo resolution leads to a more direct behavior compared to your existing
technology.
Please make yourself familiar with this more sensitive behavior.
Before the Graupner|iFS system can be used, the Graupner|iFS receiver must be instructed to
communicate only with a single Graupner|iFS RF module (transmitter). This process, known as
“binding” is required only once, for each new Graupner|iFS receiver.
Note:
When binding your system you must put receiver(s) in binding mode BEFORE putting the
transmitter in binding mode.
Binding the Graupner|iFS System
3.1 Receiver
Power on your IFS
receiver by plugging power into any open port, except the port labeled “B”.
Wait for the STATUS LED to begin flashing red. Now, connect the binding plug to the port
labeled “B” (#23606 XR-12DXT “Bind”). When the STATUS LED turns solid red, remove the
binding plug. The STATUS LED will then flash red at fast rate, indicating that it is in binding
mode. If the binding was successful, the STATUS LED will turn on for a short time and then turn
off.
3.2 Transmitter
:
The transmitter modulation
must
be set to PPM, MPX, PPM18, or PPM24 prior to using this
product.
Switch to one of these modes before any use
.
Press and hold the PROG button the Graupner|iFS RF module while powering on the transmitter.
Wait until the STATUS LED changes from off to green, and then release the button.
Once the button has been released, the units should bind. The STATUS LED on the transmitter
module will turn green and the STATUS LED will turn off when a successful bind has occurred.
