PRX-4A
Power for Receiver
8
Using the PRX for the fi rst time
At this point we assume that you have read and absorbed the complete operating instructions,
especially in respect of special notes, characteristics, voltage ranges and battery types.
In the following section we assume that your system incorporates
suitable batteries, and that they are fully charged.
WARNING
When selecting your batteries it is essential to choose types of suitable
capacity and quality, depending on the number and type of servos con-
nected to the unit.
Solder a battery connector suitable for your battery to the
1.
BAT input of the PRX.
Attach the PRX e.g. with double sided tape at an appropriate spot in the model. The PRX deve-
2.
loped a degree of heat, if possible, choose a location where the air can circulate.
Connect the
3.
RX plug of the PRX to the battery socket of your receiver.
Connect to a suitable battery to the
4.
BAT input of the PRX.
If necessary, you can use a switch between the battery and the PRX. However, we recommend to
5.
connect the battery directly to the PRX, to exclude the source of error of a switch.
BAT
RX
