GRAUPNER MICRO STAR 190AX, Инструкция по эксплуатации

Страница: 22 / 44

After a fl ying session
• At the end of a fl ying session the model should be replaced in its original packaging to avoid
the danger of accidentally bending or distorting the rotors.
• If you know you will not be fl ying the helicopter for a long period, ensure that the model is
switched off, and remove the dry cells from the transmitter.
The motors become quite hot during a
fl ight, and remain so afterwards. Don’t
touch the motors until they have had
a chance to cool down to room tem-
perature.
Motor too hot!
10. Care and maintenance
• Clean the model carefully after every fl ying session.
• The model and the remote control system components should only be cleaned using suita-
ble
materials.
Please ask your local model shop for advice on this.
11. Assembly (and repair instructions)
If you have to use solvent-based adhesives, use them only in a well-ventilated room. Take was-
te adhesives and paints to your nearest toxic waste collection point. An unobstructed work area
of generous size is very helpful for all types of modelling activity.
Do not fl y the model outdoors if there is any wind.
We wish you loads of fun and pleasure fl ying your Micro Star 190 Helikopter!
Problem Cause Solution
Rotor don‘t move Helicopter battery not connected •
Weak helicopter battery •
Transmitter switched OFF •
Connect battery •
Re-charge battery pack •
Switch ON helicopter •
Rotor stops suddenly Weak helicopter battery, ESC •
shuts off for safety reasons
Re-charge battery pack •
The helicopter does
not react to the remote
control Transmitter - helicopter not con- •
nected (bound)
Transmitter batteries weak
•
Bind transmitter and helicopter, see •
chapter 4
Change transmitter batteries
•
The helicopter is hard
to control Trim (direction, yaw) not correct •
Main blades damaged •
Check the trim, see chapter 6 •
Change main blades •
12. Trouble Shooting
21
Manual Micro Star 190