Operation
Battery Connection
• Only use optional NiCd /NiMH 1.2volt, AA size rechargeable battery and Li-Po battery.
• Remove the cover and install your battery to battery socket. Then, replace the cover making sure it is closed securely.
• When low voltage warning alarm is activated, please use new battery or recharge the used battery. Please make sure the
correct polarity when installing your battery.
Low-voltage warning for transmitter battery
Please charge Nixx 4 cell battery before use. When it will beep continuously due to low voltage warning, please stop an
operation, then recharge your battery or replace it.
Battery Charging
If rechargeable battery is in use, you can charge it below 1.0A using the charging socket of the radio or after
disconnecting the battery. When charging after disconnecting battery, please sue the JR type charging socket.
Cautions
The improper use will cause fire. So please use rechargeable battery and keep the safety rules.
Reference picture (Correct polarity)
Biding and Range Test
BIND
Please put the cursor on “RECEIVER” of RF SET Manu of the Radio. And press and hold the Bind button of the receiver
during 3 seconds. And the LEDs of the receiver blink in green and red colors. At this time, please press enter at the
“RECEIVER” of the radio. After completing, the Green LED of the receiver shall be on. Otherwise, please return to the first
step again.
RF RANGE TEST
When BIND button is touched after the connection between transmitter and receiver, RF RANGE TEST is now activated. RF
TEST is continued during 99 seconds and it is automatically deactivated. RF RANGE TEST is deactivated by touching BIND
button during RF RANGE TEST mode. Please note that your model is not controlled if your model is far away from the
transmitter during Test mode due to the short transmit distance.
