Bedienungsanleitung XZ-R1 IFS
Seite 19
Ver. 1.0
3.
When you release the programming button, the STATUS LED will turn
orange
.
This means that the satellite receiver is waiting for the main receiver to
communicate.
4.
Put the main Graupner IFS receiver into
binding mode
by pressing and holding the
programming button until the STATUS LED turns
green
. Releasing the
programming button will cause the STATUS LED on the main Graupner IFS
receiver as well as the satellite receiver, to begin flashing
orange
. This means the
receivers are waiting for a transmitter module to bind to.
5.
Put the transmitter module into binding mode by holding down the PROG button
and turning on the power. Do not release the PROG button until the STATUS LED
turns
green
. Once the PROG button is released all of the STATUS LEDs will flicker
orange
and then all finally turn
green
. This indicates a successful bind has
occurred.
6.
Turn off power to the transmitter and disconnect power from the receiver.
7.
Your system is now ready to use.
Notes:
Satellite receivers operate independently from telemetry sensors, so you do NOT need to enable
the
telemetry support
(using the XDP software) for satellite receivers to function.
If you select the
TELEMETRY option
in the XDP software you will be able to see the satellite
receiver connected and view its information.
