Grasshopper 124V/48, Руководство оператора

Страница: 15 / 68

15
The Start Circuits will keep engine from
starting unless:
• Both steering levers are swung out in their
neutral locked position, and
• The PTO switch is down in it’s disengaged
position.
The Kill Circuits will stop the running engine
if:
• The operator raises off the seat any time
during operation of the machine with PTO
engaged or steering levers in operating
position.
• The steering levers are in their operating
position and the park brake lever is moved
into engaged locked (up) position.
• The park brake is set and the steering
levers are moved into their operating po-
sition.
• The operator is off the seat and the steer-
ing levers are moved into their operating
position.
• The operator is off the seat and the PTO
switch knob is pulled up to its engaged
position.
Do not operate this machine un-
less all safety systems are working
properly as described above.
Fig. 3
PRE-START CHECK LIST
Maintain desirable operational standards and
help ensure the safety of the operator by rou-
tinely checking the following on a daily basis:
• Walk around the machine and visually
check for loose or missing components.
Make sure all components are mounted
properly and are in good working condi-
tion.
• Make sure all fenders, guards and shields
are safely and securely attached.
• Make sure the discharge shield or restric-
tion plate is installed at the discharge
opening on the mower deck.
• Make sure all safety decals are clearly
readable (see page 7).
• Check hydrostatic transmission fl uid level.
DO NOT operate machine with low fl uid.
Low fl uid could cause damage to trans-
mission and loss of control of the machine.
• Check engine oil level (refer to “Engine
Manual” for proper level and type of oil
used).
Never attempt to check oil while en-
gine is running.
• Check for oil and fuel leaks.
• Clean rotating air intake screen on en-
gine. When mowing in dusty conditions,
dry grass or long grass, it may be neces-
sary to frequently clean rotating air intake
screen to prevent engine overheating.
Never attempt to clean rotating air
intake screen while engine is run-
ning.
• Check air cleaner (refer to “Engine Manu-
al”). When mowing in dusty conditions, dry
grass or long grass, it may be necessary
to frequently clean the foam pre-cleaner
and paper cartridge.
• Make sure the engine is free of dirt and
debris.
• Check fuel level. Refer to “Engine Manu-
al” for correct fuel for your requirements.
CAUTION
WARNING
WARNING