GRASS VALLEY XIP-3901, Руководство пользователя

Страница: 182 / 308

182
Configuring the XIP 3901 - UDC - IF v3.0 Application with iControl
Timing Tab
Timing Tab
This tab allows you to view the network health of the stream’s connection (link latency,
receiver buffer level, and offset time).
Media Shows the stream type. The background shows the current media status:
Green: no error
Red: error
Grey: inactive
RTP Stream Set to enable each stream receiver individually (primary and secondary).
Stream Shows the primary (ETH1) and secondary (ETH2) stream receiver status:
Green: no error
Red:
error
Grey:
inactive
IGMPv3 Source Set the source from which to receive multicast streams. With this protocol, the card deals
with a switch to subscribe to one or many streams that are coming from different sources.
Both iGMPv3 and iGMPv2 protocols are supported. Set this to 0.0.0.0 if iGMP source is not
used. The source range is 0.0.0.0 to 255.255.255.255. The default value is 0.0.0.0.
These settings can also be managed by external NMOS control. See
NMOS Panel , on
page 123.
RX Stream
Address
Set the IP address and UDP port number at which this card receives a specific stream. IP
address 0.0.0.0 disables a receiver. The default UDP port values are: 10000 for all media
receivers.
These settings can also be managed by external NMOS control. See
NMOS Panel , on
page 123.
RX Stream Port
SDP File Click to show the last SDP file received through NMOS IS-05 since the last bootup. This
window does not refresh automatically; you need to close and re-open the window to see
an update. If the card has never received an SDP file since last its last bootup, the window
will be empty.
Apply
Cancel When active, this applies or rejects your current changes made in this tab except for Audio
type and Profile
Property Description