GRASS VALLEY LDK 300, Руководство пользователя

Страница: 21 / 82

Installation | Mounting a microphone 2-7
2.6 Mounting a microphone
To attach the optional microphone (AJ MC700) to the camera proceed as follows:
1. Open the microphone holder by unscrewing the knurled screw (2) of the
microphone support bracket (1) on the viewfinder and open.
2. Slide the microphone into the split tube until the microphone shoulder reaches
the mark (5) in the tube.
3. Place the tube with the microphone into the holder with the split facing
upwards.
4. Ensure that the rubber supports at the back and front of the holder fit into the
rims (6) around the tube.
5. Close the holder and tighten the knurled screw at the top.
6. Connect the microphone cable to audio connector (3) (mic) on the right side of
the camera.
7. Place the microphone cable into the top clip at the front of the camera and
into clip (4) at the side of the camera. (Pull and twist clip to open it.)
Other microphones with a diameter of 21mm can also be used, however, ensure that
the phantom power and the sensitivity of the input that match that type of
microphone are correctly selected in the camera systems menu.
☞
Note
When longer microphones are used, it is not necessary to place them in the split tube.
For optimum operation, the microphone should be mounted as straight as possible.
Don’t allow the wind hood to touch the holder (7) as this reduces the damping effect.
By placing the split facing upwards, the microphone cable does not touch the holder
thus avoiding mechanical pick-up.
Figure 2-7. Microphone mounting
2
4
1
3
5
6
7