10
Kaleido-RCP2
Restoring Default Parameters
connections to Kaleido systems in its own subnet.
To configure a unicast IP address on the Kaleido-RCP2, do the following:
1 Press and hold the ENTER button until the ESC button lights up to access the
Configuration
menu.
2 Select
ETHERNET OPTIONS
on the LCD display, and then press ENTER.
3 Select
Unicast host IP
, and then press ENTER.
4 Select
Enable IP 1
, and then press ENTER.
The
Enable IP n
parameter instructs the Kaleido-RCP2 to query the Kaleido system at
the selected IP address for a list of rooms.
5 Select
Host IP ADDR
, and then press ENTER.
6 Using the numeric keypad, type the IP address of a Kaleido system on a remote subnet,
and then press ENTER.
7 Repeat
step 4
to
step 6
to add unicast IP addresses for up to three remote Kaleido
systems.
Restoring Default Parameters
The Kaleido-RCP2’s
Configuration
menu provides an option to restore the device’s default
parameters. This option is called FACTORY DEFAULT.
Select this option to revert the following elements to their default values:
• The network parameters.
• The room selection.
• The login position.
Once you exit the
Configuration
menu, the device will restart.
Here are the default parameter values:
Notes
• To navigate the
Kaleido-RCP2
menu, press the
2
key to move up, or the
8
key to move down.
• There is no need to configure unicast IP addresses for
Kaleido
systems on
the same subnet as the
Kaleido-RCP2
.
DHCP
Enable
IP address
10.0.3.191
Subnet mask
255.255.0.0
Gateway
0.0.0.0
Unicast IP addresses
All three host IP address parameters set
to 10.0.3.70 and disabled by default