GRASS VALLEY K2 BASECAMP EXPRESS, Инструкция по установке и обслуживанию

Страница: 318 / 366

14. In the K2Config application, do the following for each K2 Media Server with role of iSCSI
bridge to verify that you see the correct number of drives:
a) On the
iSCSI Bridge Server Configuration
page, click
View Target Drives
and proceed as follows:
• If you see all drives, both old and new, no further sub-steps are necessary. Skip to the next
step in this procedure.
• If some drives are listed as unexposed, continue with the remaining sub-steps in this step.
b) Click
Check
.
c) Restart the K2 Media Server.
d) Repeat this step to make sure you now see the correct number of drives.
15. Monitor the Restripe Utility.
On a file system with a large amount of existing media, this can take days.
NOTE: Do not stop the FTP server once the restripe process begins.
a) Record system information
Make sure you keep diagrams and other on-site documentation up to date.
Related Topics
Expanding bandwidth for Aurora products on page 318
Accessing Storage Utility on page 308
Managing the Restripe Utility on page 319
Expanding bandwidth for Aurora products
The “Expansion by bandwidth” feature is supported on K2 Storage Systems that store media from
both K2 products and Aurora products. If the storage system contains media from Aurora products
and you want to retain that media, additional steps are required, as follows:
1. Before starting the file system expansion, using Notepad or another text editor, open the following
file:
V:\VolumeConfig.xml
2. To the existing XML content, add lines with XML tags
<MainFolder>
and
<AtticFolder>
to specify the main folder and attic folder for your Aurora media. For example, if the main folder
is “VibrintAVFiles” and the attic folder is “VibrintAttic”, the resulting XML content is as follows:
<VolumeConfig>
<Type>K2 Storage</Type>
<Model>Grass Valley PFR700</Model>
<StripeSize>512</StripeSize>
<Security>Not Supported</Security>
<MainFolder>V:\VibrintAVFiles</MainFolder>
<AtticFolder>V:\VibrintAttic</AtticFolder>
</VolumeConfig>
3. Save and close the
VolumeConfig.xml
file.
4. Proceed with bandwidth expansion process.
318 K2 SAN Installation and Service Manual 02 February 2012
Administering and maintaining the K2 SAN