GRASS VALLEY IQUCP25, Руководство пользователя

Страница: 254 / 338

254
Getting Started with the Multiviewer
STEP 1.2: Preliminaries - Multiviewer SDC Templates
2 In the Configuration template (see Configuration , on page 281), configure the
following settings.
Genlock: Select the video reference signal to use.
Domain ID:
Specify the RollCall
Domain ID
to use and click
Take
.
Software Version: Under License Loaded, the status is OK .
3 In the Ethernet 1 and Ethernet 2 templates, in the Ethernet panel, define the following
for the SFP1 and SFP2 rear Ethernet interface for the media networks. See also Ethernet
Pages 1 and 2 , on page 101.
• DHCP/Static addressing mode, and so on.
• IP address,
• default gateway IP address,
• subnet mask,
Fig. 8-3: Ethernet Pane Example
4 In the
Time Sync Configuration
template (see Time Sync Configuration , on page 85),
configure the:
•
PTP Network Interface
to use; and the
• PTP Configuration items, including PTP Domain , PTP Delay Request Frequency
and
PTP Multicast
IP address.
5 Click Restart and wait for the module to reboot (approximately 75 seconds).
Wait for the module to restart and the SFP-1 and SFP-2 rear Ethernet interfaces are now
ready to be used in a target system. The Multiviewer SDC RollCall templates should now be
accessible through the media network SFP-1/SFP-2 interfaces.
6 Proceed to STEP 1.2: Preliminaries - Multiviewer SDC Templates , on page 254.
STEP 1.2: Preliminaries - Multiviewer SDC Templates
This sub-section uses RollCall templates to configure the Multiviewer SDC specific settings.
Note: The IP routing multicast IP addresses are not yet set up. This is done
later in this procedure, in STEP 2: UCP - 3901 Media Interface(s)
Setup (Video IP Streams)
, on page 255
.