GRASS VALLEY IQUCP25, Руководство пользователя

Страница: 165 / 338

165
UCP - 3901
User Manual
Ethernet Gb
For a UCP - 3901:
• The Ethernet Gb page shows details and status for the MANAGEMENT Ethernet
connector port found on the card’s rear panel. See Rear Panel and Connectors on
page 32.
• The UCP - 3901 defaults to use DHCP for the
MANAGEMENT
Ethernet port address
negotiation, but this can be overridden and a static IP address can be specified if
required.
• The management port handles card configuration and upgrade, as well as NMOS IS-04
and IS - 05 communications with the NMOS registry.
• The Ethernet configuration for this port can also be set through the frame’s control
panel. This is useful when the card is first installed in the frame, to make it quickly
operational. See Local control using the Densité frame control panel to set the Card’s IP
Addresses on page 38.
For a IQUCP25 / IQUCP50:
• The
Ethernet Gb
page displays details and the status of the ‘card front’ Ethernet port of
the IQUCP25 / IQUCP50 card. This is for Grass Valley engineering use only.
• The IQUCP25 / IQUCP50 defaults to use DHCP for the ‘card front’ Ethernet port address
negotiation, but this can be overridden and a static IP address can be specified if
required.
Only make changes to the Ethernet settings during off hours as any settings change will
take the card offline for up to 30 seconds.
See
Ethernet Pages 1 and 2 on page 101 to configure the media Ethernet configurations.
Figure 6 - 41:
Ethernet Gb Page