GRASS VALLEY 8960ENC -, Инструкция по эксплуатации

Страница: 8 / 52

8 8960ENC Instruction Manual
Installation
Installation
Installation of the 8960ENC module is a process of:
1.
Placing the module in the proper frame slot, and
2. Cabling and terminating signal ports.
Note If you are installing the optional Frame Sync Submodule on the 8900ENC, see
Frame Sync Submodule (8900FSS) on page 10 .
The 8960ENC module can be plugged in and removed from an 8900 Series
frame with power on. When power is applied to the module, LED indica-
tors reflect the initialization process (see
Power Up on page 12 ).
Frame Capacity
The 8960ENC module can be installed in all 8900 Series video frames but
with varying maximum quantities determined by frame cooling capacity.
Table 1 provides the power capacity, cooling capacity, and maximum
8960ENC module count for each frame type.
Note Module capacity figures assume no other modules are in the frame.
X = Not recommended without forced air cooling.
Module Placement in the 8900 Frame
There are ten slot locations in the frame to accommodate either analog or
digital modules. These are the left ten locations. Refer to
Figure 1 on page 9 .
The two slots on the right are allocated for the power supplies. For addi-
tional information concerning the Power Supply module, refer to the 8900
Power Supply manual.
The third slot from the right is allocated for the controller module—either
a Frame Monitor Module or a 2000NET Network Interface Module. For
additional information concerning the controller module options, refer to
the
Gecko 8900TX/8900TF/8900TFN Frames Instruction Manual.
Table 1. Power, Cooling, and Module Capacity of 8900 Frames
Capacity Calculated
8900TX
Frame
8900TF-V
Frame
8900TFN-V
Frame
Power (W) 100 100 100
Recommended Module Cooling (W) 30 90 90
8960ENC Modules 5 10 10
8960ENC Modules with 8900FSS X 10 10