GRASS VALLEY 8945EDA -, Инструкция по эксплуатации

Страница: 12 / 44

12 8945EDA/-D — Instruction Manual
Installation
Rear Module Installation
1. To remove a blank rear adapter cover (or a rear module already
present), manually loosen the two screws holding each retainer clip on
the rear adapter cover or rear module to the frame with the retainer clip
tool provided inside the front cover of the frame (751- model frames
only) or a 2 mm (5/64”) hex screwdriver.
Note To remove a rear module already installed, follow the same steps. It is helpful
to first remove the front module so the rear can be pulled out more easily.
1.
After loosening the retainer clip screws, pull up on each retainer and
completely remove it, leaving the screws in place.
2.
Remove the blank rear adapter cover by inserting the retainer clip tool
or needlenose pliers into the slots in the blank cover and pulling it off
(
Figure 2 ).
3. Insert the rear module into the empty slot, guiding it carefully into
place.
4. Replace each retainer clip over the two screws on both sides of the
module and push down to seat the retainer clip.
5. Tighten the two screws on each retainer clip just until they come into
contract with the retainer clip then tighten about a 1/4 turn more
(maximum torque is 4-5 inch-lb/0.45-0.6Nm). Do not force or torque
the screws too tightly. The clips should not bend or be bowed.
Note All unused rear slots in a GeckoFlex frame should have a blank rear adapter
cover installed.
Figure 2. Installing Rear Module
8444_23r0
U s e r etai n e r clip o r
n eedle n o s e plie rs
to p u ll o u t bla n k afte r
r emovi n g r etai n e r clip s