GRASS VALLEY 2020ADC, Инструкция по эксплуатации

Страница: 15 / 32

2020ADC — Instruction Manual 15
Power Up
A red FAULT LED indicates an error situation and, with the other LEDs,
can indicate the operational conditions presented in
Table 3 . The table
describes signal output and LED indications for various input/reference
combinations and user settings.
Table 3. Indicator LEDs and Conditions Indicated
LED Indication Condition
FAULT
(red)
Off Normal operation.
On continuously Module has detected an internal fault.
Flashing Reference input is faulty or not present.
COMM
(yellow)
Off No activity on frame communication bus.
Long flash Location Command received by the module from a remote control system.
Short flash Activity present on the frame communication bus.
CONF
(yellow)
Off Module is in normal operating mode.
On continuously
Module is initializing, changing operating modes or updating firmware. Simultaneous
CONF and FAULT LEDs on indicate FPGA load error.
Flashing Indicates rate of change of paddle-controlled analog setting.
PWR
(green)
Off No power to module or module’s DC/DC converter failed.
On continuously Normal operation, module is powered.
REM OVER
(yellow)
Off Module configuration matches switch and jumper settings.
On continuously
Module configuration may not match switch and jumper settings. Control has been
remotely overridden.
LOCK
(green)
Off Module does not detect a valid AES in reference signal.
On continuously Valid AES in reference signal is present and module is locked to it.
20 dB
CH1-4
(green)
Off Channel level is less than -20 dBFS.
On continuously Channel level is greater than -20 dBFS.
Flashing Channel level is transitioning through -20 dBFS
CLIP
CH1-4
(red)
Off Channel digitized signal level is less than -0.5 dBFS.
On continuously Channel digitized signal level is greater than -0.5 dBFS.
Flashing Channel digitized signal level is transitioning through -0.5 dBFS.