GRAPHTEC CC300-20 Craft ROBO, Руководство пользователя

Страница: 39 / 55

CHAPTER 3. CRAFT ROBO CONTROLLER 3-15
PREFACE
CH 3. CRAFT ROBO CONTROLLER
CH 1. PRIOR TO USE
APPENDIX A
CH 2. CONNECTION AND PREPARATION
INDEX
CONTENTS
CH 4. CUTTING DATA SAVED ON SD CARD
PREFACE CONTENTS CH 1. PRIOR TO USE CH 2. CONNECTION AND PREPARATION
INDEX APPENDIX A CH 4. CUTTING DATA SAVED ON SD CARD CH 3. CRAFT ROBO CONTROLLER
(1) Use the [Blade Position] buttons to move the blade or pen (ballpoint pen)
within the registration mark range. The registration mark range is displayed as
a green square in the illustration at the upper right corner of the Controller. The
position of the square may change based on the orientation of the design.
(2) Click the Registration mark reading button to start manual reading of the
registration marks.
Calibration ..................... Click this button to open the [Calibration] window.
Registration Mark Sensor Position Correction
(Displayed only for the CC330-20.)
This function is used to adjust the cut position when the printed image and the
cut position are misaligned. This operation enables the positions read by the
registration mark sensor to be adjusted to the correct registration mark positions.
CHECKPOINT
It is normally not necessary to perform this correction.
Follow the procedure described below to perform Registration Mark Sensor
Position Correction.
(1) Mount the blade plunger in the Craft ROBO.
(2) For the "Registration Mark Reading Test", use a sheet of paper with a cross
drawn on it. Follow the procedure described below to prepare a sheet of paper
with a cross drawn on it.
<If ROBO Master has been installed in your computer>
Print out the "RegistrationMarkReadingTestSheet" that is provided with ROBO
Master.
<If ROBO Master has not been installed in your computer>
Prepare a sheet of paper with a cross drawn on it to use for the "Registration
Mark Reading Test", making sure that all the following conditions are met.