Graphite 58G211, Инструкция по эксплуатации, Страница: 19 / 140

19
Drilling with the power tool at low rotational speeds may result in overheating of the motor. Make
regular breaks in your work or allow the device to work at maximum rotational speed without load
for about 3 minutes.
HOOK
The drill/driver has a practical hook ( 6 ) that can be used for example to hang the power tool on a fitter’s
belt during work at heights.
SERVICE AND MAINTENANCE
MAINTENANCE AND STORAGE
Ɣ
The power tool should be cleaned after each use.
Ɣ
Do not use water or other liquids to clean the power tool.
Ɣ
The driver/drill should be cleaned with a piece of dry cloth or with a jet of compressed air at low
pressure.
Ɣ
Do not use any cleaning agents or solvents as they may damage the plastic parts.
Ɣ
Clean the ventilation slots in the motor housing regularly so as to prevent overheating of the power
tool.
Ɣ
In the event of excessive sparking of the commutator, have the condition of the carbon brushes of the
motor checked by a qualified person.
Ɣ
Always store the drill/driver in a dry place inaccessible to children.
REPLACEMENT OF THE CHUCK
The chuck is screwed onto the thread of the spindle and also secured with a screw.
Ɣ
Set the rotation direction switch ( 5 ) in the central position.
Ɣ
Open the jaws of the chuck ( 1 ) and unscrew the fixing screw (left-hand thread) ( fig. H ).
Ɣ
Put an Allen key in the chuck and gently tap the other end of the key.
Ɣ
Unscrew the chuck.
Ɣ
In order to install the chuck, perform the above actions in a reverse order.
Any and all defects must be removed by service companies authorized by the manufacturer.
TECHNICAL PARAMETERS
RATING DATA
Cordless drill/driver
Parameter Value
Battery voltage 14,4 V DC
Battery type Li-Ion
Battery capacity 2000 mAh
Range of rotational speed in the idle gear 0-400/0-1100 min -1
Range of chuck 1-13 mm
Range of torque control 1-20 plus drilling
Maximum torque 34 Nm
Protection class III
Weight 1,52 kg
Year of manufacture 2015