6
Operation:
For first time use, follow step by step:
1.
Put the paper stack into the Jogger Tray (1)
2.
Loosen the locker (8) and adjust the Jogger Tray (1) angle from about 90 degree to 30
degrees depending on paper thickness (see Notes after this section for guidelines).
Retighten the locker (8) once set
3.
Switch on the Power Switch (6)
4.
Turn the Air Knob (2), Jog Knob (3), and Timer Knob (4) counterclockwise to bring them
to the minimum value.
5.
Click Start Button (5), the machine will be running but with little to no reaction as the
settings are at their minimum point.
6.
Adjust the air power with Air Knob (2) according to the need.
7.
Adjust the Jogger power with Jog Knob (3) according to the need.
8.
Set the running time with Timer Knob (4) according to the need.
For subsequent uses simply click the Start Button (5), as all the values set will continue
to be in effect until changed. Adjust based on variances in paper starting from minimum
to maximum settings always.
Note:
1.
Make sure Air Knob (2), Jog Knob (3), and Timer Knob (4) are set to the minimum value
when the machine is being started. Improper setting could cause light papers to blow
away or fall out of the machine if the values are too high.
2.
The Air Knob (2), the Jog Knob (3), and the Timer Knob (4) adjust separately, whether
the machine power is on or off.
3.
With thick, heavy stock adjust the angle of the jogger closer to 90 degrees.
4.
For lighter, smaller stock keep the angle of the jogger closer to the 30-degree mark.
