Graphic Products DuraLabel 7000, Руководство пользователя

Страница: 13 / 32

13
4.2 Loading the Ribbon
1. Make sure the printer is OFF
by pressing the on/off switch at
the rear of the printer near the
power cord.
2. Open the printer’s top cover by
lifting up the side panel using
the indented handle. Push the
side cover all the way up until it’s fully opened. No support is
needed; the cover will rest on its own.
3. Locate the print head release lever , a light-green lever.
4. Pull the print head release lever and turn counter-clockwise until
it is horizontal. The print area is now open.
5. Holding the roll of ribbon in your right hand, slide the ribbon onto
the ribbon supply shaft with the ribbon unrolling clockwise. Be
sure the ribbon goes under the print head assembly, but above
the vinyl supply and the media sensor.
6. Guide the ribbon under the print head, and tape the end to an
empty core on the ribbon rewind shaft.
7. Turn the rewind shaft counterclockwise to tighten the ribbon.
8. While holding the ribbon supply shaft taut, twist the print head
release lever clockwise and push back into place.
9. Lift cutter and lock into place.
4.3 Loading the Vinyl Supply
1. Make sure the printer is OFF
by pushing the on/off switch at
the rear of the printer near the
power cord.
2. Open the printer’s top cover by
lifting up the side panel using
the indented handle. Push the
side cover all the way up until it
is fully opened. No support is
needed; the cover will rest on its own.
3. Press down on the cutter release button at the front of the
machine to release the cutter.
4. Pull the print head release lever outward and turn counter-
clockwise to release the print head.
5. Unlock label supply guide and lift up.
6. Slide vinyl onto label roll bar with the supply unrolling counter-
clockwise. Lower the supply guide, and lock into place.