
Page 5
2 USING
YOUR
BOILER
2.1
LIGHTING YOUR BOILER
The lighting procedure is:
1. Ensure
that:
a) There is su
ffi
cient fuel, of the correct type, in the
supply tank and that all fuel supply valves are open.
b) The water supply is on.
c) The electricity supply to the boiler is OFF.
d) The boiler On/O
ff
switch is set to OFF.
e) The room thermostat (if
fi
tted) is at the desired setting.
f)
The boiler thermostat is set to the required setting.
2. Switch the electricity supply to the boiler ON.
3. Set the boiler On/O
ff
switch to ON.
If
fi
tted, set the programmer to ON (either central heating
(CH) or hot water (HW)).
4. The boiler will now light automatically.
5. If a programmer is
fi
tted, refer to the instructions supplied
with the programmer and set the CH and HW functions to
TIMED.
The boiler will now operate during the ‘on’ periods set on the
programmer.
2.2 IF
YOUR BOILER FAILS TO LIGHT
Make the following checks:
1. Check that the boiler On/O
ff
switch is set to ON.
2. Check that the programmer (if
fi
tted) is working and is set to
ON (CH or HW).
3. Check that all thermostats are set to the desired setting and
are calling for heat.
4. Check if the burner ‘Lock-Out’ reset button on the burner
body (refer to Figure 1-1 for location) is lit.
If it is, press it to start the burner.
If the burner fails to light and goes to ‘Lock-Out’ again, check
that you have su
ffi
cient fuel in the storage tank and that the
fuel supply valve is open.
5. Check that the
fi
re valve in the oil supply line has not tripped.
6. Ensure that a fuse has not blown or that the electricity supply
has not failed.
7. Check to see if the overheat thermostat has operated (see
Section 2.5).
If the burner still fails to light after carrying out these checks then
a fault exists or the fuel supply is low. If you have su
ffi
cient fuel,
switch o
ff
the electricity supply to the boiler and contact your
service engineer.
2.3
TURNING OFF YOUR BOILER
To turn o
ff
your boiler:
•
For short periods-
Set the On/O
ff
switch to OFF.
To restart, simply set the switch to On.
•
For long periods-
Set the On/O
ff
switch to OFF and switch o
ff
the electricity
supply to the boiler. If required, the fuel supply valve may be
closed and the water and electricity supplies turned o
ff
at the
mains.
To restart, refer to Section 2.1 (Lighting your Boiler).
2.4
ABOUT YOUR FUEL
Grant Euro
fl
ame boilers only operate on Class C2 Kerosene to
BS 2869:1998.
You should always quote this type of fuel when ordering from your
supplier.
Do not wait until the fuel runs out before you order some more
as sludge in the bottom of the tank may be drawn into the fuel
lines. If it is possible, switch o
ff
the boiler when the new supply is
delivered and leave the fuel to settle for an hour before restarting
the boiler.
2.5
BOILER CONTROLS
BOILER THERMOSTAT
This dial, located on the boiler control panel, allows the
temperature of the water leaving the boiler to heat the radiators
(and/or other heat emmiters if
fi
tted) and domestic hot water to be
adjusted.
Refer to Figure 1-1 for the location of the control panel within the
boiler casing and Figure 2-1 for the details of the control panel.
! NOTE !
If you have a cylinder thermostat on your hot water
cylinder, this will control the temperature of your domestic
hot water.
The boiler thermostat setting must be equal to or greater
than the cylinder thermostat setting to enable the cylinder
thermostat to control the domestic hot water system.
OVERHEAT THERMOSTAT
Your boiler is
fi
tted with a safety overheat thermostat which
will automatically switch o
ff
the boiler in the case of a control
malfunction causing overheating.
If your boiler goes o
ff
and you try to light it but nothing happens
and the ‘Lock-Out’ reset button on the burner is not lit, the
overheat thermostat has probably operated. The boiler will not
light until the overheat thermostat is reset.
To reset the overheat thermostat, unscrew the small plastic cap
marked “reset” (see Figure 2-1), press the button and replace the
cap.
If this condition continually repeats, contact your service engineer.
Figure 2-1:
Euro
fl
ame Condensing Utility boiler control panel
Section 2: Using your Boiler
Содержание EFCON5090IND
Страница 11: ...Page 11 Notes NOTES ...