Grant-bio PCV-2400, Руководство по эксплуатации, Страница: 9 / 16

Page 9
4.2.2 Open the lid and place EVEN number of tubes to the rotor sockets (Fig.1/ v )
opposite one another. Close the lid.
4.2.3 Press the QS (Fig.1/ w ) button for quick mixing / spinning and hold it pressed for
the desired time. The unit will automatically stop when the QS button is released.
Note! Do not open the lid whilst the rotor is moving. The unit stops automatically when the
lid is opened.
4.2.4 Turn the switch (Fig. 1/
x
) into position O (OFF).
4.3. Operation in the vortex mode:
4.3.1 Turn the switch (Fig. 1/ x ) into position I ( QS ).
4.3.2 Gently holding a tube with fingers at its upper part press the tube's lower part to the
vortex head cavity bottom (Fig.1/
u
).
4.3.3 Press QS button for mixing and hold it pressed until full sediment dissolution.
Caution! Please note that the mixing effectiveness is dependent on the angle of the tube
and the pressure applied.
To avoid premature wear of the vortex head and plastic tube's surfaces don't press
tubes to the vortex head with too much force.
4.3.4 Turn the switch (Fig. 1/
x
) into position O (OFF).
4.4. Operation in the long centrifugation mode:
4.4.1 Open the lid and place EVEN number of tubes to rotor sockets (Fig.1/
v
) opposite
one another. Close the lid.
4.4.2 Turn the switch (Fig. 1/
x
) into position II ( LS , Lon Spin) to start centrifugation.
4.4.3 Turn the switch into position O (OFF) to stop centrifugation.
4.5. Disconnect unit from the electric circuit.
Combi-spin PCV-2400
Operating Instructions Version 1.03 - July 2013