Operating method
1. Push the power supply plug (1) into the power socket, turn on the power and then set switch (12)
and knob (16) to the on position to start heating the cutter (8) and heating board (9).
2. Both of the display lamps (13) and (15) for the heating board and cutter should be lit.
3. Operation can start after pre-heating the machine for 1–2 minutes when the working temperature
of the heating board is between 100 –160 degrees generally.
4. Place the film into the support roller (3) inside of the rear chamber, buckle the belts on both ends, lift up
the upper cover (working desk) (4), pull the film between the lower guide roller (11) and the rear guide
roller (10) and feed it between both front and rear clamp rollers (6) (5), lower the upper cover to normal
position and adjust the tension handle (2) to ensure the film tension is adequate for packing.
5. Place the food or container to be packed on the upper cover, carefully grip the edges of the wrap
film, lift it clear of the grip and pull it up and to-wards you until there is sufficient film to completely
cover the foodstuff, and allowing a generous excess of film either side of the foodstuff. Fold it
over the top of the foodstuff.
6. Lift the foodstuff from the product tray and pull it towards you, drawing out more film at the same
time. At the same time as you pull the foodstuff towards you, fold the excess film either side of
the foodstuff under the product.
7. Wrap the foodstuff with the film, draw the package down so that the stretched film comes into
contact with the cutter. The cutter will heat cut the film at the point of contact.
8. Place the package on the heating board (9) for sealing, ending the packing operation.
9. Turn on the cutter switch (12) and turn off the controller switch for heating (16) if only the cutter is
needed in operation.
Caution
• Do not use the sealer in a place close to flammable materials
• Do not operate the switch or plug in or out the PS plug with wet hands
• In case of the display lamp not being lit or the cutter heating board not heating,
stop operation and turn off the power to check and troubleshoot
• Make sure to replace the fuse (14) with the original rated one (2A).
• Clean with a dry cloth in case there is dirt adhered on the cutter or the heating board
and do not use any metal or any hard matter in case it will damage the surface coating
• At the
end
of operation, take out the power supply plug ensuring not to pull it out
by holding the cord.
