6
EN
Special safety features
IMPORTANT:
This machine has a specially de-
signed safety feature: Protective cover (12).
The machine can only operate when the protective
cover (10) is closed and the jug (9) is installed prop-
erly on the motor base (6).
Preparations before installation
• Remove all protective packaging and wrapping.
• Check the machine for completeness and trans-
port damages. In case of incomplete delivery (e.g.
jug lid, etc) or damage, contact supplier immedi-
ately. DO NOT use the machine. (See == > War-
ranty).
• Clean the machine and the jug (9) before use (See
==> Cleaning and Maintenance).
• Make sure the appliance is completely dry.
Installation
• Read this manual thoroughly and carefully before
installation and operation.
• Ensure the machine is placed in a dry area and
that surface has sufficient strength to support
the machine. Also ensure there are no obstruc-
tions nearby during operation of the machine.
• Ensure that the electrical power supply corre-
sponds with the rating label on the machine.
CAUTION! Never
bypass any safety micro switch.
Transportation
• Do not move the machine while it is under op-
eration. Unplug the machine when moving the
machine.
• Always remove the jug (9) when moving.
• Lift only at the motor base (6) when moving.
Operation
Note:
For safety reason, the machine can only start to operate with the jug (9) installed properly on the motor
base (6) and the protective over (12) is closed properly.
• Check if the machine is at the STANDBY mode.
• Unplug the machine and open the protective cov-
er (12), take out the jug (9) from the motor base
(6).
• Pour all the ingredients into the jug (9) and close
it with the jug lid (10) and place the cover cap (11)
correctly in place.
• Place the whole jug (9) onto the motor base (6) &
close the protective cover (12).
• Connect the power plug to a suitable electri-
cal power supply socket and the machine is in
STANDBY mode now.
• Switch ON the machine by pressing the power
switch (1) and 20 will be shown on the digital
control display (5) or select a suitable speed by
pressing the desired speed control button (2): /
/ will be shown on the digital control display
(5) correspondingly. Default speed setting is 20
when you switch on.
• Select the time for operation (30s / 45s / 90s) by
pressing the timer button (3). Remaining time
will be shown on the digital control display (5).
Once the set time is elapsed, the machine will
stop operation and go to STANDBY mode.
• After use, always press the power switch (1) to
STANDNY mode and disconnect the plug from
the electrical socket.
Note: The digital control panel has 2 brightness in
blue colour. When you press, it will light up bright-
er (dark blue). Otherwise, it will remain in dimmer
mode (light blue).