3
4
Instructions
To ensure extra durability and safety installation brackets have been included. The necessity of brackets
will vary depending on the location of installation. For installations of sizes up to 150", use the C1 bracket.
For installations of over 150", use C2.
Installation With Brackets
Installation For Sizes Up to 150"
The screen can be installed either on the wall or with a hidden installation. The wall installation uses 2 holes
on the C1 brackets while the hidden installation uses all 3. Measure the distance between the holes that will
be used on the left and right brackets. Using the measured distance, drill the appropriate holes in the wall
(and ceiling if necessary). Install the brackets, then lift and match up the screen's end caps to the brackets.
Insert the two screws to join the bracket and screen casing for both sides.
Installation For Sizes Over 150"
Using the C2 brackets, the screen can installed from the ceiling. Measure the distance between the holes
on the left and right brackets. Using the measured distance, drill the appropriate holes in the ceiling. Install
the brackets, then lift and match up the screen's end caps to the brackets. Insert the screws to join the
bracket and screen casing for both sides.
With mounting bracket installation(
)
Optional
Hidden installation
(Suitable for all sizes)
150 inches and under hidden
wall mount installation
150 inches and up installation
Hanger
Without mounting bracket installation
Wall m ount (Suitable for all sizes)
Ceiling mount (Suitable for all sizes)
2. Automatic remote control (Please see section on Remote Control).
Picture 1
Picture 2
Picture 3
Drop Limit
Retraction Limit
Grandview projection screens are controlled by a manual switch or an automatic remote control.
1. Manual switch control
a. T
b. Connect to a power source (Please make sure it is the right voltage)
c.
; it will come down slowly. When it is all the way down, it
will stop automatically.
d. Turn the switch to
1 to
the screen; it will go up into the metal casing. When it is all the way up, it
will stop automatically.
e. To stop any time while the screen is in motion, turn the switch to 0.
ear off the glue cloth fixed on the bottom rod,ensure the bottom rod is not stuck by the casing.
Turn the switch to position 2 to lower the screen
position
lower
Attention:
> Please make sure there is no dust or dirt on the fabric surface before rolling it back to the casing
> The recommened working time is less than 50 seconds. The motor will enter overheating protection
status and stop working for every continuous 4 minuters operation, user would need to wait for a while
until the motor cool down before operating again.
> There is no lube needed for the motor. Please be noticed that the appropriate setting is optimized which
requires no further adjustment, please consult the after sales team before adjusting the limits.
