①
②
③
④
⑧
⑤
⑥
⑦
5x35 screw(4pcs)
G100
100mm
45mm
15mm
100mm
165
265
410
730
435
235
200mm
200mm
350mm
350mm
G200
G350
Diagram for applicable projector area
The installation arms support projector installation
within the diameter of 139mm – 455mm. The diameter
of the ceiling mounting holes is 153mm.
Diagram of the projector installation holes
Maximum diameter: 455mm
Minimum diameter: 139mm
Front View
Models
Outer bar's
length(X)
Inner bar's
length(Y)
Min length(mm) Max length(mm)
Components assembly and accessories
GPCM-B is combined by GPC and GPM
Specifications
Models
GPCM-G series
Max load
20kgs
Length
100/200/350
Unit(mm)
Components:
Omament cover
①
Length adjustable screw
②
Main bar
③
Sub-bar
④
Angle adjuster
⑤
Fastener
⑥
Installation arm
⑦
Cables duct
⑧
Parts:
M3x20 Cross round screw(4pcs)
M4x20 Cross round screw(4pcs)
Allen key(1pc)
Rubber insert
M5x20 Cross round screw(4pcs)
GPC
1.Assembly
The main bar and the sub-bar are fixed together from factory.
Install the whole unit onto the ceiling and tighten screws
securely. Then connect the angle adjuster and tighten it with
`desired projection direction.
2.Adjustment
Loosen the screw between the main bar and sub-bar. Adjust
the length of the bar by selecting the available screw holes
on the sub-bar. Tighten the screw once desired length is
confirmed.
GPM
1. Adjust the installation arms to match with the projector mounting holes. Ensure the
projector is in the center of the angle adjuster. Tighten securely.
2. Make sure the direction of theangle adjuster and the projection is the same.
3. The Installation arms are extendable to match with the projector mounting.
4. If the projector has only 3 holes mounting, simply take out 2 of the installation arms
and use only one arm to match with the available hole. Reserve the left installation
arm in proper place for future use.
figure 4
figure 5
figure 6
Three steps mounting:
A.Mount the whole GPC
unit on the ceiling and
tighten securely
.
B.Connect the GPC and GPM
together after the projector is
properly mounted with GPM
as instructed.
C.Adjust your desired angle
.
Optional
accessory
Main bar
