background image

Quick Installation Guide

 5-Port Gigabit PoE+ Switch (30W) 

Table of Contents

 Introduction …………………………………………………..

 Power Over Ethernet (PoE) & Features  ……..…………..

 Unpacking and Installation ……… .………………………..

 System Requirement…….  .………………………………..

 Front Panel /LED….………………………………………….

 Hardware Installation… …………. …………….……….…..

 Technical Specification……………………………………....

 

 Troubleshooting ………...……………..……..……………...

Page 2

Page 2

Page 3

Page 3

Page 4

Page 5

Page 6

Page 7

FCC Warning:

This device has been tested and found to comply with the regulations for Class B digital equipment. 

Pursuant  to  Part 15  of FCC Rules.  These  limits  are  designed  to  provide  reasonable  protection against 

harmful  interference  when  the  equipment  is  operated in a  commercial  environment. This equipment 

generates, uses, and can radiate radio frequency  energy  and,  if not installed  and  used in accordance 

with users guide, may cause harmful interference to radio  communications. Operation  of this device in  

a residential area is likely to cause  harmful interference, in  which  case  the  user  will  be  required to 

correct the interference at his/her own expense. 

    

CE Mark Warning:

 This  is  a  Class  B  product. In a domestic environment, this product may cause radio interference, in which 

case the user may be required to take adequate measures. 

UL Warning:

1> Elevated Operating Ambient Temperature- If installed in a closed or multi-unit rack assembly, the 

operating ambient  temperature of the rack environment may be greater then room ambient. Therefore, 

Consideration should be given to installing the equipment in an environment compatible with 

manufacturer’s maximum rated ambient temperature

2> Reduced Air flow-installation of equipment in a rack  should be such that the amount of air flow required 

for safe operation of the equipment is not compromised.

3> Mechanical Loading- mounting of the equipment in the rack should be such that a hazardous 

condition is not achieved due to uneven mechanical loading.    

Important

This user guide contains information on the limitations regarding product use and function and 

information on the limitations as to liability of the manufacturer. Read the entire guide carefully 

5-Port Ethernet Gigabit PoE Switch               Rev 1.0    01/03/2013    Page 1 OF 7

Содержание POE-5000








Отзывы: