P a g e
|
32
DP760 User Manual
Version 1.0.3.34
DP760 DECT REPEATER ASSOCIATION WITH DP750
After factory reset, DP760 will be set to “Auto-region” mode. In this mode, the three LEDs of right side keep
quick blinking, then the DP760 will search the base signal in the current environment to auto associate with
it and then auto switch to the same region (EU, US or BR) of the base station.
Enabling Repeater Mode on DP750
Before associating the DP760 DECT Repeater to your DP750 Base Station, you should firstly enable the
repeater mode on your base station. Please refer following steps to enable the repeater mode on the DP750
base station:
1.
Access the Web GUI of your DP750 using the admin’s username and password. (Default username
and password are:
admin/admin
).
2.
Navigate to
DECT
General
Settings
and set
Enable
Repeater
Mode
to
Yes
.
Figure 10: Enable Repeater Mode
3.
Press
Save and Apply
, then
Reboot
the base to apply the new settings.
DP760 DECT Repeater Association
After enabling the repeater mode on DP750 Base Station, you can easily associate it with your DP760
DECT Repeater using one of the following methods:
•
Auto Association
•
Manual Association
•
Use DP750 Repeater Management to associate DP760
Note
: Using auto/manual association methods, the DP760 repeater will no
t be listed on DP750 “DECT
Repeater Status” page even if “Repeater Management Mode” is enabled on DP750.
