GRANDSTATE 11111652 E, Безопасность, установка, эксплуатация и техническое обслуживание

Страница: 17 / 52

17
Setting up the grill
After purchasing your gas cylinder you will then be ready to set it up with your gas grill.
a) When changing the gas cylinder which shall be carried out away from any source of ignition.
Position the gas cylinder in the cabinet gas cylinder holder.
b) When ready to use your gas grill insert the regulator into the gas cylinder valve and tighten firmly.
The recommended hose length is about 1.0 m. The hose must not be longer than 1.5 m.
c) Place the gas barbecue on an evenly flat and straight surface. Otherwise there is a risk that the gas cylinder
could fall over. In addition, positioning on uneven ground can result in a slight inclination of the doors, which
can be corrected by moving the device on a straight surface.
Always check for leaks after every change of gas cylinder
Check all gas supply fittings for leaks before each use. It is handy to keep a spray bottle of soapy
water near the shut-off valve of the gas supply line. Spray all the fittings. Bubbles indicate leaks.
Warning
Since this barbecue has no restriction in the emission of unburned gas, this barbecue must be installed
and/or used outdoors or in an amply ventilated area.
Strongly recommends minimum clearances from combustible materials must be:
Rear – 600 mm
Sides – 500 mm
Top – 1000 mm
Strong wind is not allowed
to blow through the back
openings of the gas grill.
Energy saving tips
a) Reduce the opening time of the lid.
b) Turn the grill off as soon as cooking is completed.
c) Preheat the gas grill for 10 to 15 minutes only. (Except for the first use)
d) Do not preheat longer than recommended.
e) Do not use a higher setting than required.
> 500 mm
> 1000 mm
> 600 mm
> 500 mm