grandimpianti GD6C, Инструкция по установке, эксплуатации и обслуживанию

Страница: 43 / 77

The machine will not start
Check
• that the door is properly closed.
• that the main power switch is on.
• that the plug is connected.
• that the fuses (circuit breakers) in your house
are intact. Swap two circuit breakers over to
make sure. You cannot always tell from the
outside if a circuit breaker is broken.
• that the overheating cut-out has not been
triggered (see below).
• that the lint filter is in place and is clean.
Overheating cut-out
The overheating cut-out shuts off the tumble dryer
if the temperature is too high, e.g. because dust
is clogging the lint filter.
• Clean the lint filter.
• Check also that the condensed water container
is not full and, if necessary, clean the
condenser. See the chapter “Care and
cleaning”.
• The overheating cut-out will reset automatically
once the machine has cooled down.
Drying takes too long
• Empty the condensed water container and
check that neither the lint filter nor the
condenser are clogged. See the chapter "Care
and cleaning".
• Overly long drying times may also be due to
the tumble dryer being located in a confined
area or room that is too small, causing the air
to become too hot.
• Make sure that the tumble dryer has access
to more cold air, open doors and/or windows.
The washing does not dry, or is too
dry
• The door has been opened while the
programme is running, which disrupts the
moisture monitoring function.
Error messages
• If “Over Flow” is shown in the display, the
condensed water container is full. Empty the
container and restart the programme.
• If "Max program time" appears on the display,
the maximum programme time has been
reached. Read "Drying takes too long" in the
"Troubleshooting" chapter to find out what to
do.
• If "Clean lint filter" appears on the display,
clean the lint filter.
• If "Clean condenser" appears on the display.
See the "Cleaning the condenser" section of
the "Care and cleaning" chapter for remedy
• Press the Stop button to close error messages.
• The tumble dryer cannot start if the lint filter is
not in place. The error message "Insert filter"
appears on the display.
16
Troubleshooting
www.groupdynamics-laundry.com
sales@groupdynamics.lv