DRY2568N_SVG
Dry
TLW2192N_SVG
Signal (select models only)
DRY2574N_SVG
Door Open
DRY2547N_SVG
Heating
DRY2675N_SVG
Cooling
Digital Display
The two-digit display is used to show the time remaining in a cycle.
The display also shows diagnostic codes.
Idle Mode
If no keypads have been pressed for five minutes after a cycle is fin-
ished, the control will enter Idle Mode. A light in the lower right cor-
ner of the digital display will flash once each minute. Press the Pow-
er/Cancel keypad to exit this mode.
Cycles
The following cycle descriptions will help determine which cycle to
choose depending on the type of laundry being dried. The cycle set-
tings may be modified using the Selections and Options.
Auto-Sensing
The Auto-Sensing drying cycle operation is determined by the type
of cycle selected as well as the moisture sensing system, which can
be set by changing the Dryness setting. Auto-Sensing cycles are
Energy Saver cycles that help prevent over-drying.
When a wet load is put into the dryer it takes a certain amount of
time to reach the desired dryness level. The time will vary with load
size, type of fabric, amount of moisture in the load, air flow and the
laundry room environment. The estimated time will be shown in the
digital display.
Cycle
Use
Regular
Use for sturdy items like play or
work clothes.
Cycle
Use
Perm Press
Use for permanent press items
and synthetics.
Delicate
Dry delicate items on this cy-
cle.
Manual
There are three manual cycles: Time Dry, Quick Dry and Fluff Up.
These cycles will run for the set number of minutes shown on the
digital display. The cycle time can be increased or decreased using
the up and down arrow keypads. The time and temperature selec-
tion may be adjusted manually at any time before or during the cy-
cle.
Selections
The following selections can be used to modify the currently chosen
cycle. The default selections will be lit after choosing a cycle.
Temp
Press the Temp keypad to change a Manual cycle’s temperature.
Choose from No Heat, Low or High.
Dryness
Press the Dryness keypad to change the dryness level in an Auto-
Sensing cycle. Choose from Damp, Near Dry or Dry.
Damp
Leaves load slightly damp for
easier ironing.
Near Dry
Use for normal loads.
Dry
Use for heavy items such as
blue jeans and blankets.
Over-drying can cause wrinkling, shrinking, excessive lint conditions,
and will use more energy than necessary. To increase energy sav-
ings and to make sure loads are dried without over-drying, set your
Auto-Sensing loads on Near Dry. If items are damp or over-dry at
the end of a cycle, increase or decrease the Dryness setting the
next time these loads are dried. Remember the settings that work
best to get ideal drying results.
Moisture Level
The Moisture Level status lights will be lit during an Auto-Sensing
cycle. The Sensing light will be lit at the beginning of the cycle.
The Wet and Dry lights will be lit based on readings from the mois-
ture sensing system.
Operating Your Dryer
10
©
Published by permission of the copyright owner - DO NOT COPY or TRANSMIT
Part No. 514820EN
