Grand TV6818E, Руководство пользователя

Страница: 24 / 24

Press after configuration of parameters to start manual scan.
(picture3.26)
If any program is detected and the scanning process is finished, system
will exit the scanning page and memorize the program, at the same
time return to the Installation Menu and play them on the right down
corner automatically (Picture 3.27)
Prior to manual scanning, you need to configure relevant parameter
including:
Freq(KHz): Scanning frequency. You can directly input numbers to
revise it via numeric keys.
The system will automatically to search all programs of the current
selected country and area.
Press to stop and exit program searching when auto-searching.
When searching finished, the system will auto exit program searching
menu, then memorize it and return to INSTALL menu. Play the stored
program on the right down corner. Picture3.27 as below:
Area searching is an AI program searching way. The searching range is
all the programs in the selected area.
Press to enter Area selection, and then press to select
your area and to confirm.
LCN is to select memorizing way (whether to store the channel following
the current CH number).
After setting, press to search programs as the picture below:
20 21
OK
Area Select menu as the following picture3.25:
Picture 3.25 Area Select
OK
Picture 3.27
Picture 3.26 Channel Search
Manual Search menu as the following picture3.28:
Picture 3.28 Manual Search
OK
Bandwidth: Set the current scanning transmission bandwidth.You ca
-n press to select bandwidth .Optional bandwidth: 6MHz /
7MHz / 8MHz.
Operation instruction
Operation instruction