GRAND EFFECTS FPGCORCOP40, Руководство по эксплуатации и обслуживанию

Страница: 8 / 12

Page 8 Fire Pits Manual Operation
Section 4. Burner Setup and Adjustment
Note: Each burner should have a flame height of approximately 12″ – 15″
from the top of the bowl.
1. The height of the flame can be adjusted at each burner by opening or
closing the ½″ gas valve or keyed valve as shown in Figure 1.
Each burner should be adjusted as required so that the flame size at
each bowl is similar in appearance to each other.
2. After all burners have been adjusted, make sure that the burner
assembly is repositioned so that it is sitting level in each bowl.
3. Install decorative rock or glass on top of the “burner support” and
burner assembly. Larger lava rock is recommended (2″ - 4″ in size). It
will work better than smaller rock.
Note: Do not use glass with propane installations. (If you use glass with
natural gas, you will need to lay down stainless mesh screen to
prevent glass from falling through.
WARNING
Use only approved decorative media to cover the burner assembly.
Lava and tumbled lava/ceramic stone and fire glass are all accepted
media.
To avoid the risk of property damage and serious injury, including death,
use caution when in the immediate area, as pieces may pop or explode
when exposed to heat or when wet and exposed to heat.
Important: Do not use fire glass with propane installations.