3
Grand Canyon Gas Logs---3435 E. Atlanta Ave---Phoenix, AZ 85040
Typical Fire-Pit Installation
The above diagram is an illustration of a typical fire-pit installation with Hot Surface Electronic ignition system.
Some parts may not be applicable for match lite models.
GAS CYLINDERS
1.
This appliance shall be used with NATURAL and LP inlet gas supply only. The LP or CNG gas supply cylinder
must be constructed and marked in accordance with the specifications for LP-gas cylinders or CNG-gas cylinders
of the U.S. Department of Transportation (DOT).
2.
The use or storage of the LP or CNG cylinder may not be used in a building, garage or any other enclosed area.
3.
Cylinders must be stored outdoors in a well-ventilated area out of the reach of children. Disconnected cylinders
must have threaded valve plugs tightly installed.
4.
If the appliance in not in use, the gas must be turned off at the supply cylinder
5.
Inspect the hose before each use of the appliance. The hose assemble must be replaced prior to the appliance
being put into operation if there is evidence of excessive abrasion or wear, or if hose is damaged. The hose
assembly must be replaced with a replacement hose assembly equivalent to, or greater than, rating specified
on the original hose.
6.
The gas hose shall be located out of the pathways where people may trip over it or in areas where the hose
may be subject to accidental damage.
7.
Never use matches or open flame to test for leaks. Use soapy water or a leak detector.
8.
Don not store or use LP-gas supply cylinder around excessive heat; the cylinder may get too hot or cause the
pressure to rise. Store the cylinder in a secure upright position.
9.
Cylinder must be fully opened and the pressure controlled by reducing pressure regulator to operate properly.
