Granby Cast Iron Boiler Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 7 / 34

7
3.3 JACKET ASSEMBLY AND CONTROL INSTALLATION
The boiler jacket has been designed for ease of assembly and removal. The following are step
by step instructions. A philips screwdriver, 17mm socket and ratchet, 17mm wrench or
adjustable wrench are needed.
STEP 1: VERIFY CONTENTS OF JACKET ASSEMBLY PACKAGE.
Your jacket assembly will contain boiler block insulation, rear of block insulation, front panel
insulation, two (2) side panels, rear panel, top panel, front panel and a fastening package with
screws and foil tape for fastening insulation. See jacket content photos below.
NOTE: If you are installing a 7, 8, or 9 section boiler, the jacket will be supplied in
two boxes.
Box 1: 4, 5, or 6 section boiler jacket (respectively). Box 2: rear jacket extension
which includes a top, two (2) side panels, block insulation and additional fastening screws.