23
Installing your dishwasher
Choose a suitable location for your dishwasher. Take
care to ensure that the machine is standing safely and
levelly.
Unevenness in the floor can be equalised by adjusting
the screw feet. When the machine is standing correctly,
the door can be closed without difficulties.
Water inlet and drainage hoses must be placed so
that they can move freely in order to avoid bending or
squeezing them.
The machine may not be hooked up in rooms with a
temperature below 0° Celsius.
Water connection
There are two different types of water inlet hoses:
- Cold water inlet hose (up to 25°C)
- Hot water inlet hose (up to 60°C)
please check which one is applicable to your model.
If you are willing to connect your machine to natural
energy resources or to the central hot water supply,
first check out whether your water inlet hose type is
suitable by checking the temperature values written
on the hose. If your hose is not suitable, apply to your
authorized service to change the hose.
The dishwasher may not be connected to open warm
water devices and flow-through water heaters.
Connect water inlet hose
Take care to ensure that the water inlet hose is not bent
or squeezed. Do not install a used hose set.
Use a screw-on hose connector to connect the water
inlet hose to a water tap with an external thread with a
measurement of 3/4 inches.
If required, use a filter inset to filter deposits from the
pipes.
Check that the connection does not leak.
Attention
For safety reasons, close the tap after every rinse
process.
Lowest permissible water
pressure:
0,3 bar = 3 N/cm² = 30 kPa
When the water pressure is
below 1 bar, please contact your
technician.
Permissible water pressure:
When the water pressure is above
10 bar, a pressure reduction valve
must be installed (available in trade
supply stores).
Highest permissible water
pressure:
10 bar = 100N/cm² = 1MPa
3/4
min 10
3/4
3/4 1/2
CH
DK
S
N
SF