EN
User guide
The drain tube can be cleared with a cotton
bud or a similar instrument.
Check that the tube is permanently placed with
its end in the collecting tray on the compressor
to prevent the water spilling on the electric
installation or on the floor (Fig. 7).
B) Freezer compartment
As this appliance is supplied with the NO
FROST feature it means that the defrosting is
completely automatic. No intervention from
your side is requiered. The water is collected
on the compressor tray. Due to the heat of the
compressor the water is evaporated.
Never use hairdryers, electrical heaters or
other such electrical appliances for defrosting.
Sponge off the defrost water collected at the
bottom of the freezer compartment. After
defrosting, dry the interior thoroughly (Fig. 8).
Insert the plug into the socket and switch on
the electricity supply.
Warning!
The fan inside the freezer compartment
circulates cold air. Never insert any object
through the guard. Do not allow children to
play with the freezer fan.
Never store products that contain inflammable
propellant gas such as dispensers, spray cans
etc. or explosive substances.
Don’t cover the shelves with any protective
materials, which may obstruct air circulation.
Do not allow children to play with the
appliance or the controls.
Do not obstruct the freezer fan guard to
ensure that you obtain the best possible
performance from your appliance
(Fig. 10).
Warning!
Your appliance is fitted with a circulating fan
which is essential for the performance of the
freezer. Please ensure that the fan is not
blocked (stopped) or impaired by food or
packaging. Blocking (stopping) or impairing
the fan can result in an increase of the internal
freezer temperature (Thawing).
How to reposition the doors
Proceed in numerical order (Fig. 12).
5
Replacing the interior light bulb
(Fig. 11)
In case the light bulb is not working it is easy
to replace. First make sure that the
fridge/freezer is disconnected from the power
supply by removing the plug. Take a flat
screwdriver and place it carefully without force
into the left gap between the lamp cover and
the internal cabinet. Then press the handle of
the screwdriver carefully to the left until you
notice that the left pin of the cover is
disengaged. Repeat this procedure on the
gap on the right, but now press the handle of
the screwdriver carefully to the right. If both
sides are loosened the cover can be removed
easily.
Ensure that the bulb is screwed securely in
the bulb holder. Plug the appliance into the
power supply. If the light is still not working,
replace the E14 screw-cap type 15 Watt
(Max) bulb with a bulb from your local
electrical store and then fit it. Carefully
dispose of the burnt-out light bulb
immediately.
When you have changed the light bulb please
fix the cover again in its former position. Take
care that the cover closes correctly.
