FR601-INS-LAB-RevC20 15
Heat and Massage Installation Instructions
1. Place the back cushion over the vertical bayonet lugs of the recliner mechanism. Secure
the back on each side with the threaded screw knobs per the previous
Upholstered
Back Assembly
instructions.
Raise Back to Access
Back Compartment
Heat and Massage Unit
601H Back
Shown Properly
Installed
Handheld Pendant
Storage Bracket
2. Raise the back skirt on the lower rear of the back cushion, as shown above, and use
masking or packaging tape to temporarily secure it up and out of the way. This will
permit uninterrupted access to the back compartment while making the final cable
connection.
3. Remove the handheld pendant and power cord from the back compartment. Place the
handheld pendant in the storage bracket shown above.
Control Module and Transformer Unit
4. There is only one connection to make — push the seat connector firmly into the control
module until its locking tabs snap into place as shown above.
5. Remove the tape holding the back flap. Lower the flap and seal the compartment by
pressing firmly around the edges of the back flap.
6. The Heat and Massage Unit is now ready for operation. Instructions for use follow.
s
NOTICE: Before rolling the recliner, ensure the power cord is unplugged from the AC
outlet.
Insert
Seat
Connector
Here
