LX_FR566DG-INS-LAB-RevK21 6
Upholstered Back Assembly, All Models
bracket and link to be even
threaded knob through
large hole in bayonet link
kd bracket
bayonet link
threaded knobs
upholstered back
upholstered back’s kd brackets
upholstered skirt
steel tube
mechanism’s bayonet links
1. Lift the skirt on the rear of the upholstered back. To make assembly easier, hold skirt up with
a small piece of tape to fully expose the KD (knock-down) brackets that are to be mated to the
two bayonet lugs on the recliner mechanism.
2. Remove two pre-installed threaded knobs from back (one on each side).
3. Carefully guide the upholstered back onto the mechanism, inserting both bayonet links at the
same time through the two cutouts located in the bottom of the back.
4. Push down firmly on the back until the recliner mechanism bayonet links are fully engaged
into the upholstered back KD brackets. The top of bayonet link should be even with top of KD
bracket, as shown above.
5. Once the back is properly seated onto mechanism, insert the threaded knob through bayonet
link, kd bracket and steel tube (one on each side). Secure hand tight.
6. Remove tape and lower upholstery skirt. Secure back skirt with the hook and loop strips on the
skirt.
