IN_610-620-INS-LAB-RevC22 1
620: UPHOLSTERED BLOOD-DRAW / PHLEBOTOMY CHAIR WITH PADDED
ARMS - ASSEMBLY AND OPERATION INSTRUCTIONS
SAVE THESE INSTRUCTIONS FOR FUTURE USE
WARNING: Important! Read and understand these instructions before assembling or using
the Blood-Draw / Phlebotomy Chair. If you do not understand any part of these warnings,
cautions or instructions, contact a healthcare professional for direction in the use of
this product. If the Blood-Draw / Phlebotomy Chair is not properly assembled and used,
personal injury and damage to the Blood-Draw / Phlebotomy Chair could result.
WARNING: If components are damaged or missing, contact your dealer immediately. DO NOT
use substitute parts. Use only Intensa replacement parts. Non-Intensa replacement parts
could cause personal injury and damage to the Blood-Draw / Phlebotomy Chair.
WARNING: This product can expose you to chemicals including Di(2-ethylhexyl)phthalate
(DEHP) which is known to the State of California to cause cancer and birth defects or other
reproductive harm. For more information go to
www.p65warnings.ca.gov/furniture
.
WARNING: 620 Chair maximum weight capacity is 800 lb (363 kg), EVENLY DISTRIBUTED.
WARNING: Intensa, Inc. assumes no responsibility for any damage or injury caused by
improper installation or use of this product.
INTENDED USE
The Blood-Draw / Phlebotomy Chair is intended as a medical-room chair where a patient can sit
comfortably to allow medical personnel to draw blood.
620 Blood-Draw / Phlebotomy Chair
UNPACKING
Check for any obvious damage to the carton or contents (after unpacking). If damage is evident,
immediately notify the carrier and Intensa.
Open the box and carefully remove the assembled frame and other components. Inside the box are:
1) One frame with seat and arm receivers attached and arms installed
2) One back
3) Four washers and four #10 x 2" Phillips flat head wood screws (to attach back to frame)
4) One Wireform Wallsaver, if ordered
