19
7.2.1 Basic Instruments and tools
1
、
One computer with RS232 port and one standard RS232 cable;
2
、
Wire cutters and clamps;
3
、
One electric soldering iron;
4
、
One multimeter;
5
、
One oscilloscope(voltage and current probe needed);
6
、
Diagonal pliers, snipe nose pliers, cross screwdrivers (150mm/75mm length), flat screwdrivers
(75mm length) and PVC insulating tapes etc;
7
、
Make-self tools including Balance voltage test equipments, current limiting resistors, tubes and
clamp terminals with different specifications;
7.2.2 Configuration of the Model Port on the Control Board
The Model Port (JP1) on the CNTL board should be configured as follows:
Table 6.1 Model Port Setting List
Model Type
pin1&pin2
pin3&pin4
Battery Number
pin5&pin6
pin7&pin8
pin5&pin6
6K
0
1
16
1
0
0
6KL
0
0
17
0
1
1
10K
1
1
18
0
1
0
10KL
1
0
19
0
0
1
20
0
0
0
Note
：
“1” indicates that the jumper is connected;
“0”indicates that nothing is connected
7.2.3 Configuration of the charger current on the charger Board
The Model Port on the Charger board should be configured as follows:
Table 7.3 Charger current Setting List
Charge current (A)
JP06
JP07
JP08
1A
0
0
1
2A
0
1
0
3A
1
0
0
4A
0
0
0
Note
：
“1” indicates that the jumper is connected;
“0”indicates that nothing is connected
7.2.4 Configuration of the
charge voltage
on the charger Board
Modify charger voltage according to below table to meet the setting number in control board. There are
jumpers on the charger board. Please refer to the below table to modify charger voltage.
Table 7.4 Charge Voltage Setting List
Battery Number
in series
Charge
voltage (V)
JP01
JP02
JP03
JP04
JP05
16
218
0
0
0
1
0
17
232
0
0
1
0
0
18
245
0
1
0
0
0
